[Octopus-users] Error: Cannot open variables file

[Alberto Castro]

The most common cause of this problem is forgetting to do "make install".

2010/2/14 Conn O'Rourke <conn.orourke at googlemail.com>:
> Dear Octopus Users,
>
> I have compiled Octopus using the pathscale 2.1.56 compilers on a Cray XT4 -
> AMD Opteron.
>
> I get an executable but when I try to run it I get the following error:
>
> *** Fatal Error (description follows)
> Cannot open variables file:
>
> I have performed a make clean before configuration and also tried setting
> OCTOPUS_SHARE to point in the appropriate direction, with no success.
>
> Any other suggestions/workarounds would be greatly appreciated.
>
> Thanks in advance,
> Conn
>
> _______________________________________________
> Octopus-users mailing list
> Octopus-users at tddft.org
> http://www.tddft.org/mailman/listinfo/octopus-users
>
>



-- 
===============================
Dr. Alberto Castro

Instituto de Biocomputación y Física de Sistemas Complejos (BIFI),
Corona de Aragón 42,
50009 Zaragoza, España.

Temporarily at:

Departamento de Física Teórica, Facultad de Ciencias,
Universidad de Zaragoza,
Pedro Cerbuna 12,
50009 Zaragoza, España.

Tel:   +34 976761000 3332
Fax:  +34 976761264
skype: alberto_c_barrigon
email: acastro at bifi.es
===============================